Lyngdorf Audio CD-1 User Manual download pdf (Page 17)

- 17 -

Firmware

Lyngdorf Audio supplies a free PC tool for upgrading the firmware of the CD-1. The latest

revision of the tool as well as the firmware can be downloaded from www.Lyngdorf.com.

Connectors

Mains Connector

Mains voltage to the CD-1 is applied via an IEC320 type connector. The supplied cable

with safety ground should be used to connect the CD-1 to a mains outlet.

WARNING: Connect the power input only to the AC source printed on the

label and the setting shown on the voltage selector switch. The warranty

will not cover any damage caused by connecting to the wrong type of AC

mains.

WARNING: Always check the correct voltage 115V or 230V operation has

been selected for the voltage in your location or c

ountry. Failure to do this

may result in serious damage to your CD-1 component.

WARNING: Always disconnect the CD-1 from the mains before changing

any connections to its inputs or outputs.

Analog outputs

The unbalanced RCA outputs are wired in accordance with normal practice:

Shell: Chassis and ground.

Pin: Hot (+).

Unbalanced analog output impedance 75 Ohm

The balanced XLR outputs are wired in accordance with IEC268:

Pin 1: Chassis and ground.

Pin 2: Hot (+).

Pin 3: Cold (-).

Shell: Chassis and ground.

Balanced analog output impedance 100 Ohm

1 2 ... 12 13 14 15 16 17 18 19 20 21

No comments

Lyngdorf Audio CD-1 User Manual Page 17